FAQ

Do I have to change my switchboard?

No, we provide you with a completely retrofit solution. The Cubical switch goes right behind your existing switchboards without any additional rewiring.

Does your product require any extra wiring?

No, our product does not require any kind of extra wiring and is perfectly compatible with your existing switchboards.

Will configuring too many Cubical devices load up on my Wi-Fi router?

No, our product is enabled with the mesh network technology wherein all the Cubical devices act as a repeater unit of its own and hence the signal hops from one Cubical device to another without loading up on the Wi-Fi router.

Can I integrate my existing cameras with your product?

We can integrate your wireless IP cameras with our product.



No, the mechanical switches will continue to function even after you install our product in your house.
We integrate our product with your existing Wi-Fi router. In order to run the mobile application inside your house, you will not require internet connection. For controlling your house from outside, you would need internet on your mobile phone as well as inside your house.
The Cubical Master is a completely retrofit product. Ideally it should be placed centrally inside the house within the range of the Wi-Fi router.
Dimming is possible in fans as well as lights. For lights, we suggest our customers to get dimming feature for halogen bulbs, incandescent bulbs and dimmable LED(s) which are available in the market.
You can control upto one heavy device with every Cubical switch.
All appliances which come with a rating greater than 650 W are considered as heavy devices. Devies such as AC, geysers and refrigerators fall under this category.
For every Cubical Master, we can integrate upto two wireless IP cameras. We limit the number of cameras because we do not intend to impose unnecessary load on your Wi-Fi network by adding more independent devices.
We are constantly driven to provide you with the best and safest solution. The encryption used by our protocol is the AES 128 bit which is the same as in any credit card transaction.
Our device can be configured with both Static as well as Dynamic IP.
In case you forget your password, you can always reach us at our helpline. Our support team will provide you with an activation link on your registered email ID where you can reset your password.
Our energy analysis is in perfect sync with the original energy consumption in your house. Our device functions on current sensing technology and the data obtained is the most accurate figure.
We provide you services at your doorstep. We have our team of installation personnel who will do the setup and integration for you, at no extra cost.
For every Cubical Master, we can integrate upto 20 Cubical switches which essentially provides you control of upto 120 appliances with a latency of 200ms.
Yes, our device has been designed taking into consideration the spacing behind your switch board and fits easily behind the panel.
Certain older models of fan regulators may have incompatibilities with the system. We suggest you to either permanently turn off regulators in switch board or use the capacitive regulators recommended by us.
The Cubical Master has an internal memory of 8GB that is reserved for system usage. In addition to this, we can expand the storage upto 32GB using the external USB drive storage.
Yes, you can use the same set of login credentials across multiple devices for simultaneous control.
The current state of the appliances remains the same when the power resumes after an outage. The Master will store the states in the memory and they will be displayed exactly as left earlier.
All six switches can be dimmed with the Cubical Hex switch controller.
Cubical only supports the integration of switch based AC curtain motors. Two basic actions can be provided - full separation and full closure.
Top